Wire Well Logging Techniques

A. Electric, Radioactivity and Acoustic (Sonic) Logging

Subsurface geological information can be obtained by wireline well-logging techniques. Measurements are made of the electrical, radioactive and acoustic properties of rocks and their contained fluids encountered in the wellbore. Several types of measurements produce information on formation rock acoustic velocity, density, radioactivity, porosity, conductivity, resistivity, fluid saturation and permeability.

Rock lithology, formation depth and thickness and fluid type can also be determined. Caliper logs measure borehole diameter. Geologic maps and cross-sections are readily constructed from a variety of well-log data and assist in understanding facies and geometric relationships and the locations of wildcat and development drilling sites.

Logs are obtained by lowering a sonde or tool attached to a cable or wire to the bottom of a wellbore filled with drilling mud. Electrical, nuclear or acoustic energy is sent into the rock and returns to the sonde or is obtained from the rock and measured as the sonde is continuously raised from the wellbore bottom at a specific rate.

The well is logged when the sonde arrives at the top of the interval to be investigated. Formation water saturation, permeability, porosity, radioactivity and resistivity are rock properties that affect logging and the types of logs to be obtained.

As a wellbore is drilled the rock formations and their contained fluids are penetrated by the bit and affected by the drilling process. Drilling mud invades the rock surrounding the wellbore, affects the logging of the hole and must be accounted for. A permeable, porous formation which has been penetrated and affected by drilling and invasion by drilling mud, develops parameters important to logging. Significant of these parameters from the center of the wellbore outward into the formation are hole diameter, drilling mud, mudcake, mud filtrate, flushed zone, invaded zone and uninvaded zone.

B.Spontaneous (Self) Potential Logs (SP Logs)are used to detect
permeable formations and their upper and lower contacts, volume of shale, where present, in permeable formations, and to determine the resistivity of water in permeable formations.

C.Resistivity logsillustrate permeable formations, formation fluid (water
versus petroleum) content, and the porosity characteristics of formation resistivity. Resistivityrepresents the tendency of rock materials and their contained fluids to resist the flow of electrical current. Salt water contains dissolved salt and, because it conducts electricity very easily, has low resistivity. Fresh water contains no salt and demonstrates low conductivity and high resistivity. Rock materials that contain salty or fresh water offer differing degrees of resistivity and response on resistivity logs.Formation
resistivity is measured by induction electrical logs.

D. Radioactivity logsare gamma-ray, neutron and density logs,which are
often obtained together.

Gamma-ray logs measure formation radioactivity and are useful in identification and correlation of formation rock types. Gamma-ray logs are useful in estimating shale volume in potential or actual reservoir sandstone or carbonate.

Neutron logs illustrate formation porosity by measuring hydrogen ions. Water/oil-filled, shale-free, clean formations will be logged as liquid filled porosity. Zones of low porosity on the neutron log correspond to zones of higher radioactivity on the gamma-ray log and are reflective as approximate mirror images of each other.

Density log evaluates formation porosity. It detects gas, evaluates hydrocarbon density and complex rock sequences, identifies evaporate minerals and shale-bearing sandstone units. It is often taken in the same log suite as gamma-ray logs.

E. Acoustic logsillustrate formation porosity. The acoustic log measures the
velocity of a sound wave through a rock medium. Sound wave velocity is
dependent upon lithology and porosity. The sonic logillustrates both the sound wave transit time, which indicates sound velocity and the related porosity of the rock.

KEYS

Keys to unit 1

chapter II

Ex. 3

1-F, 2-F, 3-T, 4-F, 5-T

Ex. 4

1-g, 2-h, 3-e, 4-a, 5-f, 6-c, 7-b, 8-d

Ex. 5

Well, depositions, move, pressure

Ex. 10

1 - salt water, 2 - the petroleum reservoir, 3 - oil and gas, 4 - the pore, the wells, 5 - “Dissolved-Gas-Drive”, 6 - type of drive

A crossword puzzle

Across: 1) wellhead, 2) viscosity, 3) permeability, 4) deposition;

Down: 1) oil, 2) petroleum, 3) porosity, 4) trap

chapter III Ex. 3 1-e, 2-a, 3-d, 4-b, 5-c Ex. 4 1-c, 2-e, 3-a, 4-d, 5-b, 6-f, 7-g Ex. 11 1-a, 2-c, 3-b, 4-a, 5-c chapter IV (part 2) Ex. 9 1-F, 2-F, 3-T, 4-T, 5-T Ex. 10 1-c, 2-e, 3-a, 4-f, 5-b, 6-d
chapter V Ex. 8 1-c, 2-d, 3-e, 4-a, 5-b chapter VI Ex. 5 1-c,2-f, 3-a, 4-e, 5-g, 6-d, 7-b Ex. 6 1-e, 2-a, 3-f, 4-c, 5-d,6-b Ex. 10 1-c, 2-d, 3-b,4-a, 5-e
chapter VII Ex. 5 1-с, 2-d, 3-e, 4-b, 5-a chapter VIII Ex. 3 1-T, 2-F, 3-F, 4-F, 5-T Ex. 4 1-e, 2-a, 3-f, 4-b, 5-c, 6-d Ex. 5 1-e, 2-f, 3-a, 4-c, 5-b, 6-g, 7-d

CONCLUSION/ Заключение

 

После проработки и изучения материалов учебного пособия «Английский язык в сфере нефтяной и газовой промышленности» студенты бакалавры и магистры первых и вторых курсов очной и заочной формы обучения, обучающихся в высших учебных заведениях по специальностям 130101.65 «Прикладная геология», 131000.62 «Нефтегазовое дело», 151000.62 «Технологические машины и оборудование» и магистров направления подготовки 131000.68 «Нефтегазовое дело» сформируют умение беседовать на профессиональные темы, разовьют умение читать специальную литературу разной степени сложности и извлекать из неё информацию. Данное пособие рекомендуется использовать как для аудиторной, так и для самостоятельной работы.

При составлении текстов и упражнений авторы уделяли большое внимание повторяемости лексических и грамматических явлений и придерживались постепенного нарастания трудностей. Тексты профессиональной направленности адаптированы к целям профессионально-ориентированного преподавания английского языка в ВУЗе и сопровождаются системой языковых и речевых упражнений, направленных на развитие навыков чтения, понимания, обсуждения, реферирования, перевода специализированных текстов, расширение словарного запаса по темам, связанным с различными аспектами сферы нефтяной и газовой промышленности.

REFERENCES/ БИБЛИОГРАФИЧЕСКИЙ СПИСОК

 

1. http: //www. wikipedia.org/

2. http: //www.brainyquote.com/words/gr/gravity170416.html

3. http: //www.geosurvey.co.nz/services.html

4. http: //www.fe.doc.gov/education/energylessons/oil/oil2.html

5. http: //www.en.wikipedia.org

6.. http://www.geosonicsvibratech.com/mining.html

7. http://www.careersinoilandgas.com

8.http://www.shell.com

9. http:// www.bakerhughes.com

10. http://www.ipaa.org/

11. http://energy.gov/fe/science-innovation/oil-gas-research

12. Dictionary for the Petroleum Industry, Schlumberger, Austin, Texas, 1997

13. C.W. Fetter: Applied Hydrogeology, New York. MacMillan, 1994

14. Francis S. Manning, Ph.D., Richard E. Thompson, Ph.D., P.E. “Oilfield processing”, Tulsa, Oklahoma, USA, Penn Well Publishing, 1995.

15. Jeremy Comfort, Steve Hick, Allan Savage, Basic Technical English, Oxford University Press, 2002

16. Johnson C.N. & D. General Engineering Prentice Hall, Europe, 1998

17. Journal of Petroleum Technology (2000-2005), SPE, USA.

189. E.A. Keller, D.B. Botkin Essential Environmental Science. John Wieley & Sons, Inc., 2007

19. Michael Frankel “Facility piping systems hand book”, USA, McGraw-Hill Companies. Inc., 2002.

20. Norman Hyne “Dictionary of Petroleum Exploration, Drilling & Production”, Tulsa, Oklahoma, USA, 1998.

21. E.V. Pinniter: Hydrogeology, Cambridge 1993

22. Petroleum Engineering Handbook, Society of Petroleum Engineers, Richardson, TX, USA, 1992

23. H. Rabia “Oilwell Drilling Engineering, Principles and Practice”, London, 1995.

24. Wood`s Illustrated English-Russian/ Russian-English Petroleum Technology Dictionary, ALBION, WOODS Pub.

25. Белоусов В. «Нефтегазовая промышленность. Основные процессы и англо-русская терминология». – М.: ООО «Техинпут», 2006.

26. Булатов В.В., Пальчиков В.В. «Англо-русский словарь по нефти и газу». – М.: Руссо, 2001.

27. Васильев Г.Г., Коробков Г.Е., Коршак А.А. и др. «Трубопроводный транспорт нефти», М., «Недра-Бизнесцентр», 2002.

28. Григорьева М.А. Методическое пособие по усвоению терминологической лексики, развитию навыков чтения литературы по специальностям: Химическая технология природных энергоносителей и углеродных материалов, Геология нефти и газа. )». / Астрахан. гос. техн. ун-т, Гуманитар. ин-т, Каф. "Иностр. яз. в инженерно-техн. образовании";— Астрахань: Издательский отдел АГТУ, 2008г.